|B2 super battle droid|
B2 super battle droid
|Chronological and political information|
The B2 super battle droid (SBD) was an upgraded version of the B1 battle droid, with superior armament and armor. They were manufactured after the invasion of Naboo proved need for stronger droids. B2s were used by the Trade Federation, the Techno Union, and later, on a much larger scale, the Confederacy of Independent Systems. Some units were later reactivated on Mustafar by Gizor Dellso and other members of the Separatist holdouts, and the Galactic Alliance also used some B2 units during the Yuuzhan Vong War.
One of the main design flaws of the standard B1 battle droid was its reliance on a Droid Control Ship to provide a signal; if the ships were disabled, the battle droids would become useless. To remedy this, the super battle droid did not rely on such a signal and had a greater capacity for independence. However, the droid still operated best with a command signal, otherwise they tended to forget about enemies as soon as they moved out of visual range. Also, the sturdy frame of the super battle droid was larger and more heavily armored than those of a B1.
Unlike its predecessor, the B2's delicate processing unit and signal receptor were buried deep inside the torso, offering much more protection from enemy fire. Small dual laser cannons were mounted on their right forearms, along with a triShot weapon system. The B2's forearms could also be replaced by rocket launchers. They could use external weaponry (except in rocket launcher configuration), though their large hands had difficulty with smaller blasters. Instead, they were equipped with special blaster rifles that only responded to signal emitters built into the hands. For the sake of efficiency, they used many B1 parts. Their feet were also outfitted with specialized equipment for difficult terrain, such as climbing claws. Their arms also were modular, capable of exchanging their laser cannon for grenade launchers and other specialized weaponry.
When they were not using their built-in laser cannons, they had their right forearm locked upright.
As heavy infantry droids, B2s could take much more punishment than their flimsy predecessors. Even after being defeated, they could detach their torsos and keep up an attack although this was detrimental to their combat skill. Despite such traits some models seemingly suffered low heat tolerance and were subject to bursting into flame upon contact.
Most post-Battle of Geonosis B2 droids were capable of communicating with each other using an oversimplified version of Galactic Basic Standard.
- "They've sent in the supers!"
- ―Various clone troopers
The B2 was preceded by the lesser-used prototype beta version. Soon after the Invasion of Naboo, the Trade Federation was researching a new type of battle droid. Commandos from the Royal Naboo Security Forces seized the research facility and discovered the data about this new battle droid.
Super battle droids saw use throughout the Clone Wars as soldiers for the Confederacy along with its smaller cousins and the dreaded droidekas. Though the first super battle droids seen on Geonosis wore an unpainted dull silver tone, many of the droids used in later battles of the Clone Wars were painted dark blue, likely to differentiate them from the tan coloration the Confederacy used for its standard battle droids, or perhaps due to varying manufacturers.
Some Super Battle Droids were used as scouts to observe the plains of Geonosis, mostly because of their brute strength and their ability to destroy modest ground targets. This pleased many of the local Geonosians affiliated with the CIS, thus sometimes using the B2s as "spire guards."
The droids eventually were able to express certain emotions, though having catastrophic grammar. They possessed a more violent temperament than the B1 model, to the point they would even strike down allied units in order to quickly intercept enemy targets, as seen in the Battle of Geonosis. As well as that, they were also considerably more durable and intelligent, capable of easily withstanding light blaster bolts.
Super battle droids were often retrofitted with adversarial specific parts. However, this method was introduced late in the war and had little effect on the outcome of the conflict. One known model change was the introduction of the grapple droid, which had heavier armor and a larger frame. This droid was programmed to be a close combat model able to receive primary lightsaber slashes and disable enemies through its electrified claws. Another specialized variant was involved in the release of the swamp gas toxin on Ohma-D'un. The D-60 assault droid, another variant, was used in the Battle of Cartao by CIS forces. two jetpack-equipped variants of the droid, the jump droid, and the rocket droid, where also developed. Other variants included super battle droids armed with various weapons, such as the Mortar Super Battle Droid, the Anti-Air Super Battle Droid, and the Repeater super battle droid. A more heavily armed and armored version was the Heavy super battle droid, and orray troopers were B2 droids armed with flamethrowers which rode orrays. These variants were produced at Geonosian troop centers.
The B2 battle droid was designed by the Techno Union using the existing B1 design as a template. After prototypes were successfully tested, Count Dooku struck a deal with Poggle the Lesser, Archduke of Geonosis, to mass produce these droids.
Further orders were placed on worlds controlled by Baktoid and quadrillions of B2s were soon running off the assembly lines. Despite their advantages and ease of production, however, they were not manufactured as extensively as their inferior cousins, the B1s.
During the Clone Wars, B2s would become an important component of the Separatist Droid Army. They participated in most battles in that conflict including the Battle of Geonosis, Battle of Muunilinst, Battle of Coruscant, and Battle of Kashyyyk, and innumerable others throughout the galaxy. B2s were used as shooting range targets as part of the training of clone sharpshooters. A training model was used on Kamino for the training of Clone cadets.
A few years after Order 66, Gizor Dellso reactivated a Droid Foundry on Mustafar. Among the reactivated production lines were a few lines that produced B2 battle droids, providing Dellso with an acceptable amount of B2's in his droid army.
After the Clone Wars, a few entrepreneurs found warehouses filled with the droids. Many were sold to gangs or major crime lords for enforcement. Others would be used by the various Separatist holdouts. Like some B1 battle droids, B2s were also used as guards inside the Death Watch bunker on Endor.
Behind the scenes
- LEGO Star Wars: The Video Game
- LEGO Star Wars: The Complete Saga
- LEGO Star Wars: The Quest for R2-D2 game
- LEGO Star Wars: The Quest for R2-D2 film
- LEGO Star Wars: The Padawan Menace
- Star Wars: The Clone Wars: Sharpshooter (Appears in hologram) (Ambiguously canonical source)
- Star Wars: The Clone Wars: Live Fire (Ambiguously canonical source)
- Always count your clones before take-off
- Path of the Jedi
- Star Wars: Republic Commando: Order 66
Notes and references